Main


Its Got to Stop Somewhere
October 2011
Older
Newer
Its Got to Stop Somewhere
Rear bump stops

The rear bump stops are built to last. I was thinking of only using one per side but then decided to go overboard and do two. They are angled slightly outward so that if one side is drooping and the other side compressed it wont put too much side loading on it. The bottom plate is 1/4 and the sides are 1/8. I left a gap on the inside so that I could get at the nuts. The bumps themselves are just some generic Energy Suspension product (PN: 9.9136). I wanted something that with a lot of height so that they might have more give and a softer stop.

Older
Newer



thanks
contact
disclaimer
off-runner